Data as of: 2026-08-05 Administration DE EN
Plant Protection Product Search

« Indications · to the product

TEBU 25

Use number: 00A352-00/01-025

Crops
florist's chrysanthemum
Pests
white rust of chrysanthemum (Puccinia horiana)
Area of use
Outdoors
Field of activity
Fungicide
Application technique
spraying
Note on the crop
NNCLX
Applications per crop
Applications per growing season
1
Type of authorisation
Permit (minor use)
authorised until
2027-08-15

Application rates

ConditionProduct rateWater rate
0.5 LH 300 – 400 LH

Pre-harvest intervals

CropPre-harvest intervalRemarksexcluded
florist's chrysanthemum The setting of a PHI is without any relevance.

Timing of application

Restrictions

Code Text Crop Buffer zone
NW605-2 When applying the product on areas adjacent to surface waters - except only occasionally but including periodically water bearing surface waters - the product must be applied with equipment which is registered in the index of 'Loss Reducing Equipment' of 10 September 2013 (Federal Gazette AT 23.10.2013 B4) as amended. Depending on the drift reduction classes for the equipment stated below, the following buffer zones must be kept from surface waters. In addition to the minimum buffer zone from su
SS227 If repeated contact with the freshly treated crops during the application cannot be avoided, a liquid-tight protection suit must be worn.
SS120-1 Protective gloves (plant protection) must be worn when handling/applying the product ready for application.
SF278-21ZB During the first 21 days after application in ornamentals and nursery, it must be ensured that the working time in treated crops is limited to a maximum of two hours per day. Long-sleeved working clothes, sturdy footwear and protective gloves must be worn.
SF276-EVZB For the period after application in ornamentals and nursery until the end of the vegetation period or end of crop management, it must be ensured that long-sleeved working clothes, sturdy footwear and protective gloves are worn during successive work/inspections with direct contact with the treated crops/areas.
NW701 Between treated areas which have an incline of more than 2 % and surface waters - including periodically but excluding occasionally water-bearing surface waters - there must be a buffer zone under complete plant cover. The buffer zone's protective function must not be impaired by the use of implements. It must be at least 10 m wide. This buffer zone is not necessary if: -sufficient catching systems are available for the water and soil transported by run-off, which do not flow into surface water
NW606 The only case in which the product may be applied without loss reducing equipment is when at least the buffer zone stated below is kept from surface waters - except only occasionally but including periodically water bearing surface waters. Violations may be punished by fines of up to 50 000 Euro. 10 m